Bully Dog 40602 Adjustable Power Punch - Manual (Page 5)

4
InStALLAtIon InStructIonS:
1. Locate the fuel pump plug under the hood and on top of the fuel pump, it is not necessary to remove the hood
for the install. The fuel pump and plug are located on the left side of the tractor if you are facing the front of the
tractor. Identify the plug by looking for a six prong plug with a green bushing, identical to the Bully Dog plugs
on the Power Punch power module.
2. Disconnect the stock female plug from the stock male plug.
3. Connect the Bully Dog female plug up to the stock male plug, which is stationary on the tractor, push the connector
in until it snaps. Now connect the stock female plug to the male Bully Dog Plug.
4. Mount the module box in a safe location using the velcro pad. Use the zip ties to secure the wires away from any
extreme heat and moving parts.
5. Run the flip switch into a location that is easily accessible for the operator, once the module is installed the operator
can change power levels.
installation