Bully Dog 42214 Dodge Cummins Unlock Cable - Manual (Page 2)

Dodge Cummins Unlock Cable
42214
Dodge Cummins Unlock Cable
42214
1 2
CONTENTS
Setup Preview ...........................................................2
Pre-Tune Checklist ...................................................2
Parts List ....................................................................3
Part 1 ......................................................................4-6
Pre-Install Checklist ...................................................................4
Update Your GT ..........................................................................4
Physical Installation ...................................................................5
Unlock Process ...........................................................................6
Part 2 ......................................................................7-8
Illustration .................................................................................7
Part 2 List ...................................................................................8
Part 3 ..........................................................................9
Part 3 List ...................................................................................9
Final Installation .................................................. 10
SETUP PREVIEW
THERE ARE THREE PARTS TO UNLOCKING AND THEN TUNING YOUR VEHICLE, EACH PART IS DESCRIBED BELOW:
Part 1: Initialize the unlock process using the original OBDII harness that came with the GT.
Part 2: Start the unlock process using the Bully Dog UNLOCK cable harness. (included in this kit with the red
tag/tape on it)
Part 3: Complete the unlock process and then install download using the original OBDII harness that came with
the GT.
PRE-TUNE CHECKLIST
BUSINESS HOURS
Technical support is available during regular business hours (Monday-Friday 8am-5pm MST)
and can be contacted at 940-783-9915.
INTERNET ACCESS
In the event that technical support is needed, internet access may be required to troubleshoot.
ALLOW ENOUGH TIME
Make sure you have at least two hours to complete the unlock and installation process.
CHECK YOUR BATTERY
Before installation, ALWAYS ensure that the batteries are fully charged. If you are not sure,
connect a battery charger before you begin installation.
TURN ELECTRONICS OFF
Leaving electronics on (including the stereo) may prevent a successful download. Make sure
electronics are off for the entire process.
THE UNLOCK
Do NOT interrupt or disconnect the GT at any point during the unlock process.
DO NOT connect the Unlock Cable and/or the Unlock OBDII Harness until the GT
instructs you to do so.