Brew Express BE-110 INSTALLATION - Manual (Page 18)

BrEwEr TESTING
Testing
Once BREW EXPRESS has been installed into the rough-in-box it must be tested to ensure proper operation.
1. Turn on electrical power and power switch (located on top of brewer). The brew button icon should be illuminated.
If the button icon is not illuminated, refer to the troubleshooting section of this manual.
2. Turn on water supply to BREW EXPRESS. There should be no leaks in the water connections. If water is
leaking, pull the brewer from the wall, check connections and refer to the troubleshooting section of this manual
to make appropriate corrections. If water is leaking from inside the brewer, disconnect from the rough-in-box
and contact customer service.
Test the Brewer
1. Place empty brew basket in unit.
2. Place the empty carafe under brew basket.
3. Press the “Brew” button.
4. After a moment water will begin flowing and remain on for 140 to 180 seconds (depending upon model).
5. A Beeper will sound 40 seconds after water stops flowing.
See Operation Guide from more detailed information on operating the Brew Express. Also, this guide contains
a trouble shooting section if needed.
15