Brew Express BE-110 INSTALLATION - Manual (Page 16)

13
BrEwEr INSTALLATION
6. After sheet rock screws are in place, bend tabs to finish securing
rough-in box to wall. See figures 6 and 7. Use pliers (if needed)
to bend/crimp tabs firmly to wall. Gently slide excess water
line back through grommet into wall cavity leaving top of
connector a maximum of 3” above bottom of rough-in box.
Carefully install power panel cover. All electrical wires and
connections MUST be tucked completely inside
POWER PANEL COVER, without exposing bare wiring inside
rough-in box. It is advised you contact a qualified electrician.
Be certain not to damage wires or insulation. See Figure 7
Installation of Brewer
7. Important, for the BE-104C model (single button), set 2/4 cup volume
selection switch on back of brewer prior to installation of brewer.
3" max
Power Panel
Figure 6
Figure 7