Blomberg GSN 9583 A630 - Manual (Page 31)

30 GB
and power saving. There are two options,
namely On and Off. This function is set to
“On” in the factory.
Your machine gives an audio warning
before Auto Door Open function runs. And
the door of your machine opens
automatically within 2 minutes. The lock
mechanism prevents the door from being
closed for the next 1 minute. Do not try to
close the door during this period.
The door of your machine can not be
closed for 1 minute after it is opened
automatically by the Auto Door Open
function.
Do not unload your machine for 30
minutes after the door is opened
automatically. Thus, you will obtain a
better drying performance.
Do not stand in front of the door in
order not to hinder the door when you
hear the door opening signal.
If you want to disable Auto Door Open
function:
Press On/Off button (1) to turn on 1.
your dishwasher.
Press “Function” ( 2. 4) and “Time Delay”
( 5) buttons together for 3 seconds.
“Settings Menu...X” will appear on the 3.
display, where X indicates the time
(in seconds) during which the buttons
need to be kept pressed.
After entering in the Settings menu, 4.
press Function Button ( 4) until Auto
Door Open: On appears on the
display.
Select Off with “ > - < ” Selection 5.
Buttons ( 7).
If you see “ 6. ** Stored! **” after
pressing the Confirmation Button
( 6), Auto Door Open function will be
disabled for all programs. If you
want to enable this function again,
set it to “ On” in step 5 above.
Display mode menu contains Eco and
Nrmal options. If you select Eco, your
dishwasher will decrease the screen
brightness automatically after a while
and save energy. If you select Nrmal,
screen brightness will not be changed.
Factory Settings
Proceed as indicated below to cancel
all your settings and restore the factory
settings:
1. Enter into the “Settings Menu”
(Press Function and Time Delay
Buttons together for 3 seconds)
2. When the Main Menu is displayed,
keep the Function Button pressed
until “Restore Factory Settings? is
displayed.
3. Factory Settings menu do not
have any submenus and it is
enough to press “Confirmation
Button” to reset the settings.
4. Exit the menu after “ ** Stored! **”
is displayed.
When Factory Settings? menu is
selected, following values will appear:
Language = English
Screen Brightness = 2
Contrast = 2
Display mode = Nrmal
Volume = 1
Water Hardness = 3
Melody = 3