Blizzard Lighting KONTROL 5 Skywire DMX Controller - Manual (Page 11)

Page 11
KONTROL 5 Skywire Manual Rev. A Copyright © 2013 Blizzard Lighting, LLC
may be stored in each chase. If 32 steps have been stored in a chase
and the user attempts to store an additional step, the LED display will
read FULL.
11. Hold for 3 seconds to exit programming mode. The LED
indicator above the button will extinguish.
3.4.3 Deleting a Chase Step
1. Enter programming mode as described in Section 3.2.1.
2. Using the button, select the chase you wish to modify.
3. Press the button. The LED indicator will illuminate
and the current step will display on the LED display. If there are no
steps in the chase, the display will read ST00.
4. Use the buttons to select the step to delete.
5. Press the button. All LEDs will blink 3 times, indicat-
ing the delete has succeeded. The steps following the deleted step will
move up one step, and the chase will be one step shorter. If the last
step is deleted, the previous step will be displayed. If there are no
steps to delete, the LED display will read NULL.
6. Repeat steps 2-5 to delete additional steps as desired.
7. Hold for 3 seconds to exit programming mode. The LED
indicator above the button will extinguish.
3.5 Playback
The KONTROL 5 Skywire™ features three different playback modes: Manual
Control Mode, Scene/Color/Scene Preset Mode, and Chase Mode. Additionally,
the user may trigger step changes in chase mode in one of three ways: Auto-
matically (Auto Chase Mode), Via audio signal detection (Music Chase Mode),
or Manually (Manual Chase Mode). We’ll look at all the options now.
3.5.1 Manual Control Mode
Allows the user to create a precise static color using KONTROL 5 Skywire’s 4
control faders.
1. Ensure that BLACKOUT mode is not selected, IE that the LED indicator
above the button is not lit.
2. Using the button(s), select the fixtures to be
controlled.
3. Adjust the color output using as desired.
3.5.2 Color/Scene Preset Mode
Allows the user to display one of up to 16 previously programmed color preset.
1. Ensure that BLACKOUT mode is not selected, IE that the LED indicator
above the button is not lit.
2. Select the desired scene page using .
3. Select the desired scene/color preset using .
3.5.3 Chase Playback Mode
Allows the user to display one or more of up to 16 previously programmed
chases in sequence.