Blizzard Lighting KONTROL 5 Skywire DMX Controller - Manual (Page 10)

Page 10
KONTROL 5 Skywire Manual Rev. A Copyright © 2013 Blizzard Lighting, LLC
4. All LEDs will flash 3 times, and the LED indicator for the selected scene
will now remain off. The scene has been deleted.
5. Repeat steps 2-4 to delete additional presets if desired.
6. Hold for 3 seconds to exit programming mode. The LED
indicator above the button will extinguish.
3.4 Chase Programming
A chase is a sequence of different scenes or steps which are called one after
another. KONTROL 5 Skywire™ can store up to 16 programs of 200 scenes
each.
3.4.1 Creating A New Chase
1. Enter programming mode as described in Section 3.2.1.
2. Using the button, select the chase you wish to pro-
gram.
3. Using the button(s), select the fixtures to
include in the chase step.
4. Adjust the fixture(s) output using as de-
sired, OR, to use a previously programmed scene/color preset:
5. Select the desired scene bank using .
6. Press .
7. Press . All LEDs will blink 3 times to indicate the first
step has been stored successfully.
8. Repeat steps 2-6 to store additional steps if desired. Up to 200 steps
may be stored in each chase. If 200 steps have been stored in a chase
and the user attempts to store an additional step, the LED display will
read FULL.
9. Hold for 3 seconds to exit programming mode. The LED
indicator above the button will extinguish.
NOTE: After scene programming, press the button to clear
any output, to avoid inadvertently overwriting a scene/color preset.
3.4.2 Inserting a Chase Step
1. Enter programming mode as described in Section 3.2.1.
2. Using the button, select the chase you wish to modify.
3. Press the button. The LED indicator will illuminate
and the current step will display on the LED display. If there are no
steps in the chase, the display will read ST00.
4. Use the buttons to select the position for the inserted
step.
5. Using the button(s), select the fixtures to
include in the chase step.
6. Adjust the fixture(s) output using as de-
sired, OR, to use a previously programmed scene/color preset:
7. Select the desired scene bank using .
8. Press .
9. Press . All LEDs will blink 3 times to indicate the first
step has been stored successfully. If no data has been stored, the LED
display will read NULL.
10. Repeat steps 2-9 to store additional steps if desired. Up to 32 steps