Blizzard Lighting RGBW ToughPar Satellight (Rev A) - Manual (Page 3)

Page 3
ToughPar Satellight Manual Rev. A © 2014 Blizzard Lighting, LLC
1. GETTING STARTED
What’s In The Box?
• 1 x ToughPar™ Satellight Professional LED PAR Fixture
• 1 x IP Rated AC power cord with cable cap
• 1 x Set of IP Rated DMX in/out cables
• This Lovely User Manual
Optional Accessories (sold separately)
The following accessories are available for this fixture. But the lone wolves that they are, they must
be purchased separately. Contact your authorized Blizzard Lighting dealer for pricing!
• DMX-EXT: 3-Meter IP-Rated DMX Extension Cable
• PWR-EXT: 3-Meter IP-Rated Power Extension Cable
Getting It Out Of The Box
Congratulations on purchasing one of the toughest PAR fixtures anywhere! Now that you’ve got your
ToughPar™ Satellight (or hopefully, Satellight’s!), you should carefully unpack the box and check
the contents to ensure that all parts are present and in good condition. If anything looks as if it has
been damaged in transit, notify the shipper immediately and keep the packing material for inspec-
tion. Again, please save the carton and all packing materials. If a fixture must be returned to the
factory, it is important that the fixture be returned in the original factory box and packing.
Powering Up!
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely
for a 0% to 100% switch.
AC Voltage Switch - Not all fixtures have a voltage select switch, so please verify that the fixture
you receive is suitable for your local power supply. See the label on the fixture or refer to the
fixture’s specifications chart for more information. A fixture’s listed current rating is its average
current draw under normal conditions. Check the fixture or device carefully to make sure that if a
voltage selection switch exists that it is set to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line voltage
applied. Damage to your fixture may result if the line voltage applied does not match the
voltage indicated on the voltage selector switch. All fixtures must be connected to circuits
with a suitable Ground (Earthing).
Getting A Hold Of Us
If something is wrong, just give us a call or send an email. We’ll be happy to help,
honest.
Blizzard Lighting
N16 W23390 Stoneridge Dr. Ste E
Waukesha, WI 53188 USA
www.blizzardlighting.com
414-395-8365
Email: [email protected]
Disclaimer: The information and specifications contained in this document are subject to change
without notice. Blizzard Lighting™ assumes no responsibility or liability for any errors or omissions
that may appear in this user manual. Blizzard Lighting™ reserves the right to update the existing
document or to create a new document to correct any errors or omissions at any time. You can
download the latest version of this document from www.blizzardlighting.com.
Author: Date: Last Edited: Date:
J. Thomas 11/7/2013 J. Thomas 1/31/2014