Page 12 – Blizzard Lighting RGBW ToughPar Satellight (Rev A) User Manual

Page 12

Page 12

ToughPar Satellight Manual Rev. A

Adjust the Starting DMX Address

1.) To adjust the starting DMX channel, first push the “A” button once so the
3rd (right) digit is flashing.
2.) Push the “B” button to adjust this digit to a value of 0-9.
3.) Repeating the same process, push the “A” button once so the 2rd (middle)
digit is flashing.
4.) Push the “B” button to adjust this digit to a value of 0-9.
5.) Repeating the same process, push the “A” button once so the 1st (left) digit
is flashing.
6.) Push the “B” button to adjust this digit to a value of 0-5.
7.) Pushing the “A” button once more will finalize your choice of the starting
DMX address with the value being in the range of 001-512.

Slave Mode

1.) To set the fixture in slave mode, press the “A” button until you reach “PSA”
on the LED display. This fixture is now set to slave mode and will automatically
follow the first unit in the DMX chain, aka the “Master”.

DMX Channel Mode

To set the fixture to run in either 5-channel or 9-channel DMX mode:

1.) Push the “A” button until the LED display reads “PA-”.
2.) The right digit will be flashing. Use the “B” button to switch between the
choices of “5” or “9”.

Dimming Mode

The ToughPar Satellight features ultra smooth flicker-free 32-bit dimming with 5
user-selectable dimming curves. To manually set the fixture to use one of these
5 dimming curve choices, simply do the following:

1.) Push the “A” button until the LED display reads “PD-”
2.) The right digit will be flashing. Use the “B” button to switch between the
choices of dimming curve number 0-4.

Built-in Programs

In built-in program mode, each of the 3 digits on the LED screen signify sepa-
tate meanings.

Left Digit: Shows “P”, for “Program Mode”
Middle Digit: Represents the built-in program 0-6.
Right Digit: Modifies the selected program.