Bird Technologies 5000-XT-Quick Start - Manual (Page 2)

920-5000-XT-QSG Rev A www.bird-electronic.com (866) 695-4569
Setting Up
1. Connect the sensor.
2. Turn on the DPM.
3. Zero the sensor (WPS and TPS only).
4. Turn on the RF source.
5. Take a reading.
Note:
The analog bar graph will respond immediately to changes in
the RF power. The major and minor displays will respond after a delay of
1 to 13 seconds, depending on the power level.
Shutting Down
z Press and Hold the “OK” key for 2 seconds. This will put the unit into Sleep
mode. It will stop logging in this mode.
z Press and hold the “OK” key until the “OK” key illuminates, approximately 8
seconds. Release the key after it illuminates. This will shut the unit down
completely.
TO SENSORS
WIDEBAND POWER SENSOR
DIRECTIONAL POWER SENSOR
TERMINATING POWER SENSOR
TO PC
OR
OR
TRANSMITTER/
GENERATOR
ANTENNA
ANTENNA
USB
PC
POWER METER
POWER METER
USB
SERIAL
USB
SERIAL
SERIAL USB
SERIAL USB