Bennett Marine Tournament Tab Kits Owners Manual - Manual (Page 6)

sysTem ComPonenT sPeCiFiCaTions
Trim Tabs: Stainless steel
Actuators: Upper hinge material (Part #A1103) made of flexible nylon.
Remainder of actuator made of high impact fiberglass-filled
nylon.
Hydraulic Power Unit (HPU): HPU draws approximately 18 amps (broken-in) and operates
on 12 volts DC (except 24 volt HPUs). Approximately 22
ounces of ANY TYPe AUToMATIC TRANSMISSIoN FLUID (ATF)
is required to fill reservoir to proper level for single actuator
installations. With trim tabs fully retracted, proper fluid level is
about 2" from bottom of reservoir.
The HPU forces both trim tabs full-up to full-down in 8-10
seconds, individually in 4-5 seconds. (Trim tab travel on dual
actuator systems takes twice as long).
Helm Control: Controls on 12 volt systems use 20 amp in-line fuse
(24V systems use 10 amp in-line fuse).
Hydraulic Tubing: Tubing has 1/4" outside diameter
Wire Harness: Wire colors and their functions:
Red Port valve
Green Starboard valve
Yellow Motor reverse (pump retract)
Blue Motor forward (pump pressure)
Black on HPU Ground
orange on helm control Positive
System
Specifications
(continued)