Bendix Commercial Vehicle Systems BA-921 COMP User Manual
Page 9
9
Bendix
®
BA-921
®
Compressor Installation and Application Review
Section IV
Air System Components (Cont’d)
Compressor Air Induction System - Turbocharged Compressor Applications Only
(NOTE: Testing should be performed by the engine Manufacturer)
Compressor Inlet Line
The compressor inlet line will run from the pressurized side of the engine intake
system (i.e. intake manifold) to the compressor inlet port.
Inlet line size _____________________________________
Inlet line length ___________________________________
Devices/Components (if any) in the air induction system. Describe system:
______________________________________________________________________
______________________________________________________________________
__________________________________________________________
Expected/Measured Worst Case Compressor Inlet Air Temperature: ___________
__________________________________________________________________
Recommended Test Procedure to Measure Max Compressor Inlet Temperature:
Install a temperature probe in the air compressor inlet hose or fitting as close to the
compressor as possible. Operate the vehicle such that the engine is at operating
temperature at conditions resulting in maximum inlet air temperature (i.e. engine load,
RPM, etc). Record the compressor air inlet temperature and note the ambient
temperature.
Ambient temperature during test: ___________________
Is the maximum inlet air temperature greater than 250°F? YES
NO
Maximum boost pressure @ XXXX engine rpm __________________________
(Supply maximum boost vs engine RPM curves)
Page 9 of 18