Bendix Commercial Vehicle Systems BA-921 COMP - Manual (Page 14)

14
Bendix
®
BA-921
®
Compressor Installation and Application Review
Section IV Air System Components (cont’d)
Compressor Oil Supply
Source: _________________________________________
Line size to: ____________________________________
Distance to: ____________________________________
Compressor Oil Return
Return through front flange
Return through bottom drain only
Return through both bottom drain and front flange
Measured Oil Supply Pressure (record at compressor fitting at engine idle):
_______________________________________________________
Recommended Test Procedure:
Install a pressure gauge at the oil fitting on the air compressor. Record the oil pressure
at engine idle with the engine at normal operating temperature.
Was measured oil supply pressure greater than 14.0 psi ? YES NO
Describe any auxiliary fittings at the oil supply of the compressor: __________________
_______________________________________________________________________
_______________________________________________________________________
_______________________________________________________________________
Page 14 of 18