Bendix Commercial Vehicle Systems BlindSpotter SD - Manual (Page 10)

10
3.2 TROUBlEShOOTING WIRING haRNESSES
FIGURE 8 - harneSS electrical diagram.
All wire harness connectors must be properly seated to
maintain environmental seals. Push the mating connector
until it seals with a click. When replacing a Bendix
™
BlindSpotter ® radar sensor or Operator Display Unit,
check that the wire harness connector is free of corrosion
before plugging into the new device. Check for corroded
or damaged wiring that may cause connector problems
such as opens or shorts to voltage or ground.
If the connector terminals are corroded, this may be an
indication of water intrusion into the wiring system and
possibly into the radar sensor. Replacement of the entire
harness is recommended. If any terminals are corroded,
replacement is recommended.