Brother DCP-8045D - Manual (Page 54)

4 - 5 GETTING STARTED
Sleep Time
Setting the Sleep Time reduces power consumption by turning off
the fuser inside the DCP, while it is idle. You can choose how long
the DCP is idle (from 00 to 99 minutes) before it goes into sleep
mode. The timer is automatically reset when the DCP receives PC
data, or makes a copy. The factory setting is 05 minutes. While the
DCP is in sleep mode, you will see
Sleep on the LCD. If you try to
print or copy in sleep mode, there will be a short delay while the fuser
warms up to working temperature.
1
Press Menu , 1 , 4 , 2 .
2
Use the Numeric keys to enter the length of time the DCP is idle
before it goes into sleep mode (00 to 99).
3
Press Set .
4
Press Stop/Exit .
Turning off the Scanner Lamp
The scanner lamp stays on for 16 hours before automatically
switching off to preserve the life of the lamp. You can turn off the
scanner lamp manually if you wish by pressing the
and keys
simultaneously. The scanner lamp will remain turned off until the next
time you use the scanning feature.
Turning off the scanner lamp will also reduce the power
consumption.
■
If you want to turn sleep mode off, press Secure and
Job Cancel simultaneously in Step 2.
■
If the DCP is in Sleep Mode when you change the Sleep
Time, the new setting will take effect the next time the DCP
copies or prints is restarted.
Please note that turning the lamp off regularly will reduce the
lamp’s life. Some people prefer to turn the lamp off as they leave
the office, or late at night at home. This is not necessary for
normal day to day use.