beautypg.com

Repeat on the #2 then #3 and etc, Stacker and stacker pan, Baumfolder corporation – Baumfolder Older Folder User Manual

Page 17

background image

Baumfolder Corporation

Setting up a Job – Calibration of the zero Baumset

(Continued)

Once the Baumset has been calibrated or zeroed-in the fold rollers can be set automatically
with a designated amount of paper in each Baumset or each roller can be set manually.

To calibrate rolls:

1. Be sure all rolls are closed (together). Turn tension screw until

washer (A ) is just touching Roll Brg ( B ).

2. Insert one thickness paper (small) into each Baumset ( C ) lift lever

( D ) to insert.

3. Using same type paper, cut two strips of paper 2” x 10” and insert

into rolls starting with #1 roller and proceed with same procedure
through #5. (Baumset is number 1,2,3,4,5) Insert strips on right
and left side by lifting lever ( D ) and inserting strips, or with power
off, turn sheets into rolls by turning hand wheel. NOTE: If turning
rollers backward inserting paper, rock them in forward motion to
set the gears to insure rolls together.

4. With lock screw ( E ) loose, turn tension screw counter clockwise

and pull on strip of paper at the same time until you can feel it
starting to move. Repeat same motion on other end of fold roller. Recheck to be
sure both ends of the roll has a snug drag (equal). Lock the tension setting with
lock screw ( E ). Recheck again to insure you still have same setting.

5. Repeat on the #2 then #3 and etc…

STACKER AND STACKER PAN

1. The STACKER can be placed after any of the folding sections depending on the type of

the fold being made.

2. The STACKER WHEELS are

adjustable back and forth for
different length sheets. Lay the
folded sheet/signature on the
stacker with the trailing edge
against the pull out tires on the
slitter shaft, move the stacker
wheels at the leading edge of the
sheet/signature and lock them in
place with the thumbscrews. Two
flat STACKER SPRINGS are
provided to fasten on the square
bar above the slitter shafts. These
should be bent so they hold the

Baumfolder Corporation

1660 Campbell Rd. Sidney, OH 45365 Copyright © 2002

Ph: 1-800-543-6107 Fax: 937-492-7280 email: [email protected]

17

(continued on next page)