Impositions and their setup – Baumfolder Impositions and their setups User Manual
Page 8

Impositions and their setup
16-Page booklet fold - heads out Par: 1 8pg: 1,2
16. Folds up in the first fold plate ½ the length of the sheet and
deflect past the second, third, and fourth fold plate in the
parallel unit. Score with the score blade on the top slitter
shaft in the center ½ the width of the sheet. Install another
score with the score blade on the bottom slitter shaft ¾ of
the width of the sheet measuring from the side guide as the
sheet leaves the parallel unit. Then the sheet goes onto the
cross-carrier into the second unit (8-page). Folds up in the
first fold plate ½ the width of the sheet, down into the
second fold plate ¼ the width of the sheet. It then deflects
past the third and fourth fold plates. In the parallel unit,
insert one thickness strip of the paper you are running in the
number one gapsets (both sides). Insert two thickness strip
of the paper you are running in the second, third, fourth, and fifth gapsets (both sides). In the 8-page
unit, insert two thickness of the paper you are running in the number one gapsets (both sides). Insert
four thickness strips of the paper you are running in the number two gapset (both sides), and finally,
insert 8 thickness strips of paper in the number three, four, and five gapsets (both sides).
24-page booklet
Par: 1,2 8pg: 1,2
17. Folds up 1/3 of the length of the sheet in the number one fold
plate and down 1/3 of the length of the sheet in the second fold
plate. Then deflects past the third and fourth fold plate in the
parallel unit. Score as the sheet leaves the parallel unit. Install
the score blade on the top slitter shaft in the center of the width of
the sheet. Second score with the score blade on the bottom slitter
shaft ¾ of the width of the sheet measuring from the side guide.
The sheet then travels onto the cross-carrier then into the 8-page
unit. Folds up in the first fold plate ½ the width of the sheet and
down ¼ of the width of the sheet. Then deflects past the number
three and fourth fold plates. Insert one thickness strip of the
paper you are running in the number one and two gapsets (both sides). Insert three strips of the
paper you are running in the number three, four, and five gapsets (both sides), in the parallel unit.
Insert three thickness strips of the paper you are running in the number one gapsets (both sides).
Insert six thickness strips of the paper you are running in the number two gapsets (both sides). Insert
twelve thickness strips of the paper you are running in the number three, four and five gapsets (both
sides).
( continued )
Baumfolder Corporation 1660 Campbell Rd., Sidney, OH, USA 45365 1-800-543-6107 Copyright
г 2002