Baumfolder Impositions and their setups - Manual (Page 4)

Impositions and their setup
8-Page Right Angle Par: 1 8pg: 1
6. Folds in the number one fold plate one half the length of the sheet and
deflect the second, third and fourth fold plates. Score the center of the
sheet as it leaves the parallel section. Onto the cross carrier to the
second unit (eight page) into the number one plate half of the width of
the sheet. The fold should be folded on the score. Deflect the number
two, three, and four fold plates. In the Parallel unit insert one thickness
strip of the paper you are running in the number one gapset (both sides).
Insert two thickness strips of the paper you are running in the number
two, three, four and five gapsets (both sides). In the second unit, (eight-page unit), insert two
thickness strips of the paper you are running in the number one gapset (both sides). Insert four
thickness strips of the paper you are running in the second, third, fourth, and fifth gapsets (both sides).
8-Page Two right angle oblong Par: 1 8pg: 1
7. This sheet is wider than it is long. Please remember this when we
specify one half of the sheet. Folds up in the first fold plate one half
of the length of the sheet (shortest length). Deflect the second,
third, fourth fold plate and score down the center as it leaves the
parallel unit. Go onto the cross carrier into the second unit (eight
page); into the first fold plate one half of the width of the sheet. The
fold should be on the score. Deflect past number two, three, and
four fold plates. In the parallel unit, insert one thickness strip of the
paper you are running in the number one gapsets, (both sides).
Insert two thickness strips in the two, three, four, and five gapsets
(both sides. In the second unit, (eight page unit), insert two thickness strips of the paper you are
running in the number one gapsets, (both sides). In the second, third, fourth, and fifth gapset, insert
4 thickness strips of the paper you are running (both sides).
8-Page Right Angle, Double Imposition Par: 1 8pg: 1,2,3
8. Folds up in the first fold plate one half of the length of the sheet.
Deflect past the second, third, and fourth fold plate and run three
scores where you are folding in the second unit as you leave the
parallel unit. First score between pages 1,4 and 5,8 with your score
blade on the top slitter shaft ¼ of the width of the paper. Second
score on the bottom slitter shaft ½ the width of the paper. Third score
on the top slitter shaft ¾ of the width of the paper. Going on the
crosscarrier into the second unit, (eight-page unit). Folds up in the
first fold plate in the second unit ¼ the width of the paper, down ¼
the width of the paper, and up in the third fold plate ¼ the width of the
paper. Again the folds in this unit should be on the score lines made in the parallel unit. In the
Parallel unit insert one thickness strip of the paper you are running in the number one gapsets (both
sides). Insert two thickness strips of the paper you are running in the number two, three, four, and
five gapsets (both sides). In the second unit, (eight page unit), insert two thickness strips of the
paper you are running in the first, second and third gapsets (both sides). Insert eight thickness strips
of the paper you are running in the fourth and fifth gapsets (both sides).
( continued )
Baumfolder Corporation 1660 Campbell Rd., Sidney, OH, USA 45365 1-800-543-6107 Copyright г 2002