Bang & Olufsen BeoLab 7-1 - User Guide - Manual (Page 6)

Cable connections
The loudspeaker is primarily
intended to be used in a setup
with BeoVision 7*. It may,
however, be used with other
Bang & Olufsen systems as well.
If used in a setup not including
BeoVision 7, you will require
a mains cord and a Power Link
cable. These cables are available
as optional accessories from your
Bang & Olufsen retailer.
Mains connections
The loudspeaker has two sockets
concerning mains supply.
The socket marked ~ is for mains
supply input (connection from the
wall outlet), and the other is a mains
supply output to the television.
Note: The mains cord from the wall
outlet must be fastened to the cable
clamp on the loudspeaker – as shown
on the next page.
POSITION switch
This switch has two settings: F
(Free-standing position) and W
(Wall position).
Which setting to use is explained
in ‘Adapt the loudspeaker to your
room’ (pp. 8–9).
POWER LINK socket
Use this socket to connect the
loudspeaker to one of the Power
Link sockets on the Bang & Olufsen
system – see the next page.
The socket panel is located on the rear of the loudspeaker.
*NOTE! BeoVision 7 and its
accessories are not available
on all markets.
Mains connection
to the television
POSITION switch Cable clamp
POWER LINK
socket
6