Bang & Olufsen BeoLab 7-1 - User Guide - Manual (Page 5)

b c
c
d d
c
c
a
On this page is shown how to
fasten the loudspeaker to a
BeoVision 7* stand or wall
bracket. If you wish to use
the loudspeaker with another
Bang & Olufsen system, refer
to the Guide enclosed with
the system.
a Remove the small cover on the
stand (there is no cover on the
wall brackets). Press the cover
as shown, and it will come loose.
b Fasten the bracket to the stand or
wall bracket. Use the two longest
screws (M5 × 25 mm).
c Fasten the loudspeaker to the
bracket. Use the two shortest
screws (M5 × 8 mm). However, do
not fully tighten the screws before
you have made the adjustments
mentioned below (d).
Adjustments: First, make sure that
the television is adjusted to a level
position on its stand or wall
bracket. Then use the two screws
(d) to adjust the loudspeaker so
that it is parallel to the lower edge
of the television. Align the
loudspeaker front with the
television and tighten the two
screws (c).
*NOTE! BeoVision 7 and its
accessories are not available
on all markets.
5