Bang & Olufsen BeoLab 7-1 - User Guide - Manual (Page 11)

This product fulfils the
conditions stated in the
EEU directives 89/336 and 73/23.
To get access to the approval
labels, remove the loudspeaker
front grill:
> Press the front grill a little inwards
at each end – using your thumbs.
> While pressing, move the front
grill towards the left (~ 10 mm).
The front grill can now be
removed.
Note: When attaching the front
grill again, make sure that all five
‘attach-points’ engage with the
corresponding brackets on the
loudspeaker. Do not attempt to
mount the front grill upside down
(marked on the rear by ).
Technical specifications, features
and the use thereof are subject
to change without notice!
For the Canadian market only!
This class B digital apparatus meets
all require ments of the Canadian
Interference-Causing Equipment
Regulations.
For the US-market only!
NOTE: This equipment has been
tested and found to comply with
the limits for a class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harm-
ful interference in a residential
installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions,
may cause harmful interference
to radio communications. However,
there is no guarantee that interfer-
ence will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equip-
ment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
– Consult the retailer or an
experienced radio/TV technician
for help.
3508938 0502 Printed in Denmark by Bogtrykkergården a-s, Struer