Set up the loudspeakers – Bang & Olufsen BeoLab 4 PC - User Guide User Manual

Page 5

Set up the loudspeakers

We recommend that you follow

this procedure:

– Disconnect your system from the

mains.

– Connect the loud speakers and set

the LINE IN MODE switch on

each loud speaker as explained in

‘Cable connections’ (pp. 6–7).

– Connect the entire system to the

mains again.

The loud speaker must be placed

standing upright on its base, or
fastened to one of the optional
accessories. Make the connections,
and set the switch before you
fasten the loud speaker to one of the
accessories.

Loudspeaker front and side
panels
Each loudspeaker is equipped with
one front panel and two side panels.

These panels are fastened to the

loudspeaker with three small pegs
on the rear. The front panel is
marked with a Bang & Olufsen
name plate.

To remove the panels, for example

for cleaning, just pry the three
pegs in each panel free of the
corresponding holes (A–B) in the

loud speaker. Fasten the panels
again by inserting the three pegs
into the corresponding holes in

the front and the sides of the

loud speaker.

Note: The product identification
and CE labels are placed on the

loud speaker body behind the side
panels.