Use your pincode, Did you forget your pincode – Bang & Olufsen BeoVision 4-37/44 - User Guide User Manual
Page 23
Use your pincode
If BeoSystem 2 has been disconnected from
the mains for 15–30 minutes, BeoSystem 2
prompts you for the pincode when you
switch it on. You may not be able to switch
the system on immediately – wait
approximately 30 seconds and try again.
Did you forget your pincode?
Contact a Bang & Olufsen retailer to receive a
fi ve-digit mastercode.
Switch BeoSystem 2 on…
BeoSystem 2 prompts you for
your pincode
Enter your pincode
The picture appears when the
last digit is entered
If an incorrect code is entered,
ERROR is shown. Re-enter the
code
To cancel a code entry…
Press to cancel a code entry, and
the input fi elds are cleared
Five incorrect entries cause
BeoSystem 2 to shut down for
three hours, during which time
operation is not possible.
When you have received a
mastercode…
When BeoSystem 2 prompts you
for your pincode, press and hold
l to bring up the mastercode
display
Entering this fi ve-digit code
deactivates your pincode and
reactivates BeoSystem 2.
DELETED is displayed
To use the pincode system
again…
Follow the procedure for
activating the pincode system
PIN _ _ _ _
0 – 9
PIN * * _ _
PIN * * * *
ERROR
PIN _ _ _ _
STOP
PIN _ _ _ _
l
PIN _ _ _ _ _
0 – 9
DELETED
23