Network factory default setting (for hl-5070n), Network factory default setting (for hl-5070n) -11 – Brother HL-5050 User Manual
Page 93
CONTROL PANEL 3 - 11
Network factory default setting (For HL-5070N)
If you wish to reset the print server back to its default factory settings (resetting all information such as
the password and IP address information), please follow these steps:
1
Turn off the printer.
2
Make sure that the front cover is closed and the power cord is plugged in.
3
Hold down the Go button as you turn on the power switch. All the LEDs will light up. Keep the button
pressed down until the Toner LED comes on. When the Toner LED comes on, release the Go
button.
4
Hold down the Go button and keep it pressed down until the yellow Status LED comes on. When
the Status LED comes on, release the Go button.
5
When all the LEDs light up again, the printer will start warming up. The print server has been reset
to its default factory settings.
■
If you wish to reset the printer and automatically disable the APIPA protocol, follow steps 1 to 4
above, however, hold down the Go button until the Status LED is green, not yellow.
■