Linksys 0/100 LA N C a r d - Manual (Page 45)

Linksys EtherFast Series
42
5. If the LAN driver is not located in the default directory, specify the file's
path on the command line. The LOAD command prompts you for the con-
figuration parameters if they are not supplied on the command line.
6. At the server command line, type (for example):
LOAD c:\LNE100\NBI31X.NLM
LOAD c:\LNE100\MSM31X.NLM
LOAD c:\LNE100\ETHERTSM.NLM
LOAD c:\LNE100\LNE100TX.LAN FRAME =
in use>
7. Bind a protocol to the driver. For example:
BIND IPX TO LNE100TX NET=XX
where XX is the logical network address for
your network. It can be any logical number.
The loading and binding are complete. The server is ready.
Installing a 4.x Server
1. At the NetWare prompt (indicated by the server name), run the
INSTALL.NLM program by typing load install.
2. Select Maintenance/Selective Install and press Enter.
3. Select LAN Driver Options and press Enter.
4. Press the Insert or Ins key on your keyboard to insert a new driver. Put the
EtherFast Card Driver Disk into drive A.
5. Press F3 and specify the driver path. If the EtherFast Card disk is in drive
A, for example, type a:\netware\server\nw411 and press Enter. The pro-
gram will locate the EtherFast Card’s LNE100TX.LAN and
LNE100TX.LDI files on the disk.
6. The LNE100TX.LAN driver will appear as an option in the Select a LAN
Driver field. Choose this driver to start the loading and binding procedure.
N No otte e:: You can save the
LOAD command line
parameters in a file with the
name AUTOEXEC.NCF so
they execute automatically
when the server starts. See
the Novell NetWare 386
v3.12 Installation Manual for
details on how to create the
AUTOEXEC.NCF file.
LNE100TX v4 test doc.qxd 3/22/00 4:14 PM Page 42