Linksys 0/100 LA N C a r d User Manual

Page 36

EtherFast

10/100 LAN Cards

13. Click Finish. When asked if you want to restart your computer, remove

the Driver Disk and click Yes.

14. Once your PC has rebooted and you are logged in, double-click the

Network Neighborhood icon on your desktop. Ensure that you have
access to the network. If you do, your card has been properly installed.

• If you had previously installed any NT service packs, you must go back

and re-install those service packs now.

• If you need to install the TCP/IP protocol, refer to your system adminis-

trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol

The Windows NT Installation and Setup of the EtherFast 10/100 LAN
Card is complete. Do not continue on with the next set of instructions.
They are for NT users who already had their networking configured.

otte

e: If you had previously installed any NT service

packs, you must re-install them. Otherwise, you may
receive Not Enough Service Storage Space errors in
the Event Viewer.

LNE100TX v4 test doc.qxd 3/22/00 4:14 PM Page 33