Linksys 0/100 LA N C a r d - Manual (Page 19)

Linksys EtherFast Series
16
Windows 95 Installation &
Setup
Overview
After installing the EtherFast hardware in your computer, follow these
instructions for installing the network driver. The installation procedure for
the network driver will vary slightly depending on the version of Windows 95
you are using and your current system configuration. For troubleshooting tips
during setup, refer to page 45.
There are different versions of Windows 95:
• Version A
• Version B (also known as OSR2)
The installation procedure for the network
driver will vary slightly depending on which
version of Windows 95 you are using. To
begin the driver installation, and to determine
which version of Windows 95 you are using:
1. If you already haven’t, start up your PC.
2. Windows 95 will automatically detect the EtherFast Card in your com-
puter. If an Update Device Driver Wizard window (below, or another simi-
lar window) appears, you are using Windows 95 version B. If not, you are
using version A. Skip to page 52.
N No otte e:: During the installation,
Windows 95 may ask you for a
c
co om mp pu utte err o orr w wo orrk kg grro ou up p n na am me e. If
so, skip ahead to the instructions
on page 21. Once you have
established your computer and
workgroup names, go back to
where you left off and continue
with the installation.
LNE100TX v4 test doc.qxd 3/22/00 4:12 PM Page 16