Linksys 0/100 LA N C a r d - Manual (Page 44)

EtherFast ® 10/100 LAN Cards
Novell NetWare Server Setup
Overview
The EtherFast Card network driver will be automatically installed during all
of the following NetWare installation procedures. During the setup you may
want to refer to your NetWare Installation Manual for help.
• To Install the NetWare 5.x Server software on your PC, go to page 43.
• To Install the NetWare 4.x Server software on your PC, go to page 42.
• To Install the NetWare 3.12 Server software on your PC, continue below.
Installing a 3.12 Server
1. Create a directory in the DOS partition of your file server called LNE100.
2. Copy the following files from the EtherFast Card Driver Disk to your file
server's new LNE100 directory:
a:\netware\server\nw31x\NBI31X.NLM
a:\netware\server\nw31x\MSM31X.NLM
a:\netware\server\nw31x\ETHERTSM.NLM
a:\netware\server\nw31x\LNE100TX.LAN
3. Following the Load LAN Driver Module instructions in your Novell
NetWare 386 v3.12 manual, start NetWare and configure the server (if you
haven’t already).
4. Load the above LAN drivers using the LOAD command.
41
N No otte e:: If, after any of these installations, the operating system asks you
for a slot number, NetWare needs to know which PCI slot your card has
been installed to. The slot variable can be added to the driver line as
shown in the example below:
load c:\lne100\lne100tx.lan slot = 3
frame = ethernet_802.2 name = nserv
bind ipx to nserv net = 15
In this example, the card is in slot 3, the frame is Ethernet_802.2, the
net value is 15 (arbitrary) and the name is nserv (arbitrary name).
LNE100TX v4 test doc.qxd 3/22/00 4:14 PM Page 41