Braun ULTRA SERIES 05 L200UARS - Manual (Page 8)

Page 6
Lift Terminology
Lift Components (continued)
details regarding the outboard roll
stop are provided in the Pre-Lift
Operation Notes section (pages
17-20).
Roll Stop Latch: The spring-
loaded latch locks the outboard
roll stop in the vertical position
when the platform raises above
ground level.
Inboard Roll Stop: L211UARS
platforms are equipped with a
fixed inboard roll stop. Attendant
operation is not required for
operation.
Manual Operation Systems:
Manual operation systems are
provided for use in event of
power or equipment failure.
L200UARS Series lifts are
equipped with an “over-center”
fold actuator manual release
system to allow the lift platform to
be manually unfolded and folded.
A manual back-up hand pump is
built into the pump module. The
lift platform can be lowered and
raised using the hand pump.
Complete details and manual
operating procedures are pro-
vided on pages 31-40.
Lift Actions and Functions
UNFOLD (Out) - Platform
Unfold: Unfold is the action of
the platform rotating out and
down from the fully-stowed
(vertical) position to the fully-
unfolded (horizontal) position
when the UNFOLD (Out) switch
is pressed.
DOWN - Platform Lower: Down
is the action of the platform
lowering when the DOWN switch
is pressed. When the platform is
unfolded from the stow position,
the platform must be lowered
from the fully-raised position to
the floor level position when
unloading a passenger at floor
level. The lift operator (atten-
dant) must stop the platform at
floor level (release DOWN
switch). The platform is then
lowered to ground level (fully-
lowered) to unload and/or load
passengers.
DOWN - Roll Stop Unfold
(Deploy): When the platform
reaches the fully-lowered (ground
level) position and the DOWN
switch is continually pressed, the
outboard roll stop rotates down