Yamato Scientific RT200 Solvent recovery unit - Manual (Page 8)

6
Installation
This equipment is used to collect the solvent in the rotary evaporator.
Specifications for built-in condenser and flask
Condenser: Hard glass, Surface area of condenser
Flask: Hard glass, 500ml round flask
Installation method
The normal installation method is shown below.
A cooling water circulation system and vacuum pump are required in use in addition to the RE main
unit.
Connect the vacuum hose between the exhaust nozzle of vacuum pump and IN nipple on the
RT200, as shown in the figure. The end connection of exhaust piping and cooling water piping on
the RT200 model are placed on the back surface of main unit.
Connected to the nozzle
on the back surface of RT200
IN
OUT
真空ポンプ
IN
OUT
To ventilation system
(such as a draft chamber)
Cooling water
circulation system
or tap water
Exhaust IN
Exhaust OUT
Cooling OUT
Cooling IN
Vacuum pump
Location of nipple connecting with the hose
Cooling IN
Cooling OUT
Vacuum exhaust IN
Vacuum exhaust OUT