Yamato Scientific RT200 Solvent recovery unit - Manual (Page 10)

8
Long storage and disposal
When not using this unit for long term / When disposing
CAUTION!
When not using this unit for long term…
• Turn off the power and disconnect the power cord.
WARNING!
When disposing…
• Keep out of reach of children.
• Remove the residual solvent inside the equipment before disposing it. Consult with the
specialized disposal services when disposing the equipment.
Environmental protection should be considered
We request you to disassemble this unit as possible and recycle the reusable parts considering to the
environmental protection. The feature components of this unit and materials used are listed below.
Component Name Material
Exterior Parts
Outer and inner covering
Steel printed coating, ABS resin
Door Acryl resin
Handle Zinc alloy chrome-plating
Main Parts
Condenser, Solvent collecting flask
Hard glass
Nipple connecting to a hose Stainless steel and brass
Hose Silicon hose and rubber hose
Heat insulation material Expanded polyethylene, polypropylene and polyurethane
Sticker Resin material
Trouble Shooting
Phenomenon Check point
The equipment fails to collect the solvent.
Solvent odor
• The cooling water temperature is too high.
• Check if the vacuum pump is actuated.
• Check if the piping is correct.
In the case if the error other than listed above occurred, turn off the power and disconnect the
power cord immediately. Contact the shop of your purchase or nearest Yamato Scientific Service
Office.