WORX WU288 12V 1.3 Ah Lithium Ion 3 in 1 Impact Driver - Manual (Page 7)

7
Technical data
Voltage 12 V
No load speed
Screwdriver mode 0-600/min
Drill mode (Lo-Hi) 0-600/ 0-2200/min
Impact driver mode 0-2200/min
Impact rate 0-3000/min
Max torque
Impact driver mode 100N.m
Drill mode 15N.m
Torque setting 22
Drilling capacity
Wood 20mm
Steel 8mm
Chuck type 6.35mm (1/4”) hex
Charging time 30min
Machine weight 1.2kg
Noise information
A weighted sound pressure L
PA
: 77.9dB(A) K
PA
: 3.0dB(A)
A weighted sound power L
WA
: 88.9dB(A) K
WA
:3.0dB(A)
Wear ear protection when sound pressure is over 80dB(A)
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Vibration information
Vibration total values (triax vector sum) determined according to
EN 60745:
Typical weighted vibration
Vibration emission value
a
h
=3.74 m/s 2
Uncertainty K = 1.5m/s²
warning: The vibration emission value during actual use of the
power tool can differ from the declared value depending on the ways
in which the tool is used dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained
The use the correct accessory for the tool and ensuring it is sharp and
in good condition.
The tightness of the grip on the handles and if any anti vibration
accessories are used.
And the tool is being used as intended by its design and these
instructions.
this tool may cause hand-arm vibration syndrome if its use is not
adequately managed.
warning: To be accurate, an estimation of exposure level in
the actual conditions of use should also take account of all parts of
the operating cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total working period.