WORX WU288 12V 1.3 Ah Lithium Ion 3 in 1 Impact Driver - Manual (Page 10)

10
oPeRatioN
iNStalliNG oR ReMoviNG a Bit HolDeR, Socket oR
ScRewDRiveR Bit (See B)
To install the desired bit, pull the collet locking sleeve (7) forward and
insert the desired bit into the sleeve as far as it will go. Then release
the collet locking sleeve to secure the bit.
To remove the bit, pull the collet locking sleeve (7) forward and take
the tool out firmly.
oN / off SwitcH (See c)
Depress the On/Off switch (5) to start and release it to stop your tool.
The on/off switch is fitted with a brake function which stops your
chuck immediately when you quickly release the switch.
It is also a variable speed switch that delivers higher speed and
torque with increased trigger pressure. Speed is controlled by the
amount of switch trigger depression.
warning: Do not operate for long periods at low speed
because excess heat will be produced internally.
SwitcH lock
The switch trigger can be locked in the OFF position. This helps to
reduce the possibility of accidental starting when not in use. To lock
the switch trigger, place the rotation control in the center position.
ReveRSiBle (See c)
For drilling and screw driving use forward rotation marked “
”
(lever is moved to the left). Only use reverse rotation marked “ ”
(lever is moved to the right) to remove screws or release a jammed
drill bit.
warning: Never change the direction of rotation when the
1
2
3
4
8
A D1 E
B D2
C D3