WORX WU288 12V 1.3 Ah Lithium Ion 3 in 1 Impact Driver - Manual (Page 13)

13
drill bits in good condition. always use a magnetic bit holder
(not included) when using short screwdriver bits. when screw-
driving, apply a small quantity of liquid soap or similar to the
screw threads to ease insertion.
iMPact DRiveR oPeRatioN
Slide the function mode selection switch (9) to mark “ ”.
The adjusting ring can be aligned in any torque levels for this
operation.
DiSPoSal of aN eXHaUSteD BatteRy Pack
Li
To preserve natural resources, please recycle or dispose of
the battery pack properly. This battery pack contains Lithium
batteries. Consult your local waste authority for information
regarding available recycling and/or disposal options. Discharge
your battery pack by operating your tool, then remove the battery
pack from the tool housing and cover the battery pack connections
with heavy-duty adhesive tape to prevent short circuit and energy
discharge. Do not attempt to open or remove any of the components.
oveRloaD PRotectioN
When overloaded, the motor comes to a stop. Relieve the load on the
machine immediately and allow cooling for approx. 30 seconds at the
highest no-load speed.
teMPeRatURe DePeNDeNt oveRloaD PRotectioN
When using as intended for the power tool cannot be subject
to overload. When the load is too high or the allowable battery
temperature of 75°C is exceeded, the electronic control switches off
the power tool until the temperature is in the optimum temperature
range again.
PRotectioN aGaiNSt DeeP DiScHaRGiNG
The Li-ion battery is protected against deep discharging by the
“Discharging Protection System”. When the battery is empty, the
machine is switched off by means of a protective circuit: The inserted
tool no longer rotates.
Maintenance
Your power tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is
normal and will not damage your power tool.
Environmental protection
Waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling
advice.
7
8
9
10