WORX WU288 12V 1.3 Ah Lithium Ion 3 in 1 Impact Driver User Manual

Page 12

set on a lower setting.
Make the setting as follows:

1 - 4

for driving small screws

5 - 9

for driving screws into soft material

10 - 14 for driving screws into soft and hard material
15 - 19 for driving screws into hard wood

20 - 22 for driving larger screws

DRilliNG oPeRatioN
Slide the function mode selection switch (9) to mark “ ”or
“ ”. The adjusting ring can be aligned in any torque levels for this
operation.
The drill has a two-speed gear control designed for drilling or driving
at LO (mark is ) or HI (mark is ) speed (See D2). When using
the drill in the LO speed range, the speed will decrease and the drill
will have greater power and torque. When using the drill in the HI
speed range, the speed will increase and the drill will have less power
and torque.

warning: to prevent gear damage, always allow the chuck

to come to a complete stop before changing the direction of
rotation or the two-speed gear control.

When drilling into a hard smooth surface, use a center punch to mark
the desired hole location. This will prevent the drill bit from slipping
off center as the hole is started. Hold the tool firmly and place the tip
of the bit at the point to be drilled. Depress the switch trigger to start
the tool. Move the drill bit into the workpiece, applying only enough
pressure to keep the bit cutting. Do not force or apply side pressure
to elongate a hole.

tungsten carbide drill bits should always be used for

concrete and masonry. when drilling in metal, only use HSS