beautypg.com

Operation, Efore, Sing the – Wood’s Powr-Grip VL2MAN User Manual

Page 10: Ifter

background image

Rev 1.0/12-12

8

VL2MAN: #35159

OPERATION

B

EFORE

U

SING THE

L

IFTER

The operator must determine whether the lifter is capable of performing each intended task, in

accordance with the SPECIFICATIONS and INTENDED USE sections of this

INSTRUCTIONS

manual. In addition, all of the following preparations must be completed prior to lifting any load.

Taking Safety Precautions

The operator must be trained in all relevant industry and regulatory standards for the operation

of the vacuum lifter in its geographical location (eg, ASME B30.20 in the USA).
The operator must read and understand this

INSTRUCTIONS

manual, including all

WARNINGS

,

before using the lifter. If necessary, contact Wood’s Powr-Grip or an authorized dealer for

assistance.

WARNING: Always wear appropriate personal protective equipment.

The operator must wear any personal protective equipment and take any other precautions

required to handle the load safely. Consult appropriate trade association guidelines to determine
what precautions are necessary for each type of load material.

Performing Inspections and Tests

Perform all inspections and tests required by the I

NSPECTION

and T

ESTING

S

CHEDULES

(see

MAINTENANCE). In addition, if the lifter has been in storage, always conduct a V

ACUUM

T

EST

before placing it in service (see MAINTENANCE).

Adjusting the Optional Center Arm

To Adjust the Center Arm Left and Right

1) Remove the cotterless hitch pins for the adjustable center arm as previously directed (see

ASSEMBLY: T

O

I

NSTALL OR

R

EMOVE THE

O

PTIONAL

C

ENTER

A

RM

).

2) Slide the center arm to the desired location on the lifter's cross beam and align the holes for

the cotterless hitch pins.

3) Reinstall the cotterless hitch pins for the center arm as previously directed.

To Adjust the Vacuum Pad Position Up and Down

1) Remove the cotterless hitch pin from the sliding hand cup mount of the adjustable center

arm, by pulling on the pull ring.

2) Slide the cup mount downward or upward to the desired position for the vacuum pad, and

align the holes for the cotterless hitch pin in the cup mount with the corresponding holes in
the center arm.

3) Secure the cup mount by pushing the cotterless hitch pin through the holes until the retaining

ball emerges on the far side of the cup mount.