Wood’s Powr-Grip P11104DC2 - Manual (Page 5)

Rev 0.3/11-13 3 P1-DC2: #35112
SPECIFICATIONS
Description: Designed for use with a crane or other hoisting equipment, P1-04DC2 lifters employ
vacuum to hold a load for lifting, and they provide manual 180° rotation and manual 90°
tilt movements for load manipulation.
Model Number: P11004DC2 P1HV1104DC2 P11104DC2
Vacuum Pads: 1 10" [25 cm] nom. diameter,
concave (Model G0750)
10" [25 cm] nom. diameter,
lipped (Model HV11)
11" [28 cm] nom. diameter,
lipped (Model G3370) (4 each, standard rubber)
Maximum Pad Spread: 49" x 10" 50" x 11" 51" x 12"
(to outer edges) [1245 mm x 254 mm] [1270 mm x 280 mm] [1295 mm x 305 mm]
Maximum Load Capacity: 2
Per-Pad: 150 lbs [68 kg] 150 lbs [68 kg] 175 lbs [80 kg]
Overall: 600 lbs [270 kg] 600 lbs [270 kg] 700 lbs [320 kg]
Lifter Weight: 85 lbs [39 kg]
Power Source: 12 volts DC, 4.5 amps
Battery Capacity: 7 amp-hours
Rotation Capability: Manual, 180°, with automatic locking at each ¼ revolution (when desired)
Tilt Capability: Manual, 90°, with automatic locking in vertical position
Options: Available with Model EO8RC1 - Remote Control System with 310-320 or 433-434 MHz
radio signal, depending on requirements in your geographical location.
See separate instructions about other options.
Operating
Elevation:
Maximum = 6000 feet [1828 meters]
Operating
Temperatures:
32° to 104° F [0° to 40° C]
Service Life: This lifter is designed to have a service life of at least 20,000 lifting cycles, when used
and maintained as intended (vacuum pads, filter elements and other wear-out items are
excluded).
ASME Standard BTH-1: Design Category "B", Service Class "0" (see www.powrgrip.com for more information)
!!–CE–!! Note: This symbol appears in the INSTRUCTIONS manual only when requirements of a CE Standard are
different from requirements of other standards that also apply to this vacuum lifter. CE requirements are mandatory in
geographical areas where CE Standards apply, but may be optional in other locations.
1
Available with optional closed-cell foam rings for rough or textured surfaces (Model P1HV11F04DC2O), as well as alternative
rubber compounds for special applications (see REPLACEMENT PARTS LIST).
2
The Maximum Load Capacity is rated at 16" Hg [-54 kPa] on clean, smooth, nonporous flat surfaces, with a friction coefficient
of 1 (see MAINTENANCE: V ACUUM P AD M AINTENANCE : Pad to Load Friction Coefficient). A qualified person should evaluate the
effective lifting capacity for the actual application. In addition to the effect of friction between the vacuum pads and load, the
lifting capacity may be affected by the following load characteristics: rigidity, strength, surface conditions, overhang, angle, center
of gravity and temperature.