Wood’s Powr-Grip P11104DC2 - Manual (Page 32)

Rev 0.3/11-13 30 P1-DC2: #35112
R
EMOTE
C
ONTROL
S
YSTEM
T
EST
If the lifter is equipped with a Remote Control System, perform this test in the environment
where the lifter is normally employed. Use the radio transmitter to activate each of the
remote functions. 27 Vary the location and distance of the transmitter in relation to the lifter, to
ensure that transmissions are effective in a variety of circumstances. 28
If the Remote Control System does not function correctly, ...
• The battery for the radio transmitter may need to be replaced.
• Metal or other electrically conductive surfaces may be causing interference between the radio
transmitter and radio receiver. Reposition the transmitter as necessary to transmit signals
effectively.
If the problem persists, repeat the test under different conditions, to determine whether there is
transmission interference in the work environment or the Remote Control System is not
functioning as intended. Correct any deficiency before resuming normal use of the Remote
Control System.
27
Use a test material with appropriate surface characteristics (see INTENDED USE: L OAD C HARACTERISTICS ) to test the apply and
release functions.
28
This may require assistance from someone near the lifter, to verify that functions are being performed as intended.