BenQ DV2050 - Manual (Page 20)

Remote Control 12
Eng
lish
Using the Remote Control
When using the remote control, aim it at the remote control sensor window on the TV. If there is
an object between the remote control and the signal remote control sensor window on the TV,
the remote may not operate.
When using the remote control, please note:
• Do not strike or drop the remote. Do not expose the remote control to liquids and do not place it
in humid environments.
• Do not install or place the remote control in direct sunlight. The heat may damage the remote
control.
• If the remote control sensor window on the TV is in direct sunlight or strong light, the remote
control may not operate normally. In this situation, change the light source or readjust the
angle of your TV, or operate the remote control from a location closer to the remote control
sensor window on the TV.
Batteries
You will need to install the supplied batteries into the remote control to make it operate follow-
ing the instructions below.
1. Open the lid of the remote control battery compartment.
2. Insert two size-AAA batteries (included).
Ensure that the batteries are inserted with the positive and
negative terminals in the correct direction corresponding to
the (+) and (-) marks in the battery compartment.
3. Close the lid of the remote control battery compartment.