Weidmuller IE-CT Cable and Installation Tester - Manual (Page 7)

19
5. Operation
5.1 Connection to Test Installation Lines
To test an installed line plug one end of the installation line to the IE-CT Mainframe and the other end to
the IE-CT Test Box.
To do a simultaneous line identification plug one IE-CT Test Box to each termination to be tested
(max. 9 Test Boxes, available as accessories).
5.2 Connection to Test Patch Cables
Installation Lines
IE-CT Test Boxes
IE-CT Mainframe
Patch Panel
Wall Outlets
Patch Cable
If you want to use the IE-CT for error detection on
patch cables, plug one end of the patch cable into
the RJ45 jack of the IE-CT Mainframe and the other
end into the RJ45 jack of the IE-CT Test Box.