Hardware installation procedure – Weidmuller IE-CS(T)-2TX Series - Industrial Ethernet Serial/Ethernet Converter User Manual

Page 4

Serial/Ethernet Converter LED Indicators (front panel)

Name Color

Function

PWR1,

Power is being supplied to power input PWR1
or PWR2

PWR2

Red

Serial/Ethernet Converter is

Blinking:

Steady on: Power is on and the

booting up.
Indicates an IP conflict, the
DHCP or BOOTP server did not
respond properly, or a relay
output occurred.

green

Steady on:

Power is on and the
Serial/Ethernet Converter is
functioning normally.

Blinking:

The Serial/Ethernet Converte
has been located by th
Administrator’s "Locate" functio

Ready

off

Power is off

n exists.

, or a power error conditio

orange 10 Mbps Ethernet connection.

green 100 Mbps Ethernet connection.

E1, E2

or has a

off

Ethernet cable is disconnected,
short.
Serial port is receiving data.

orange

green

ort is transmitting data.

Serial p

P1, P2

r received

off

No data is being transmitted o
through the serial port.

. Hardware Installation Procedure

1: After removing the Serial/Ethernet Converter from the box,

ct the 12-48 VDC

STEP 2:

STEP 3:

STEP

first connect the power adaptor. Conne
power line with the terminal block, or connect the DIN-Rail
power supply with the Serial/Ethernet Converter’s terminal
block.
Connect the Serial/Ethernet Converter to a network. Use a
standard straight-through Ethernet cable to connect to a Hub
or Switch. When setting up or testing the Serial/Ethernet
Converter, you might find it convenient to connect directly to
your computer’s Ethernet port. Use a cross-over Ethernet
cable If the PC don’t support autocrossing.
Connect the Serial/Ethernet Converter’s serial port to a seria
device.

STEP 4: The Serial/Ethernet Converter is designed to be attached to a

DIN-Rail or mounted on a wall. For DIN-Rail mounting, push
down the spring and properly attach it to the DIN-Rail until it
“snaps” into place. For wall mounting, install a wall mount kit
first, and then screw the device onto the wall. The following
figure illustrates the two mounting options:

- 4 -