Weidmuller IE-MC-VL Series - Industrial Ethernet Media Converters - Manual (Page 11)

Dip Switch Setting
IE-MC-VL Series DIP switch
1 2 3
ON DIP
Dip Switch 1 (Default: Off )
ON: Enables the PORT Alarm. If the port’s link fails, the
relay will form an open circuit and the fault LED will
light up.
Off: Disables the corresponding PORT Alarm. The relay
will form a closed circuit and the Fault LED will
never light up.
Dip Switch 2 (Default: ON )
ON: Enables full duplex for 100BaseFX
Off: Disables full duplex for 100BaseFX
Dip Switch 3
Reserved for future use
To activate the updated DIP switch setting, power off and then power on the
Media Converter.
LED Indicators
The front panel of the Media Converter contains several LED indicators. The
function of each LED is described in the table below.
LED Color State Description
On
Power is being supplied to power
input PWR1
PWR1 AMBER
Off
Power is not being supplied to
power input PWR1
On
Power is being supplied to power
input PWR2
PWR2 AMBER
Off
Power is not being supplied to
power input PWR2
On
When the corresponding PORT
alarm is enabled, and the port’s
link is inactive.
FAULT RED
Off
When the corresponding PORT
alarm is enabled and the port’s link
is active, or when the
corresponding PORT alarm is
disabled.
On TP port’s 10 Mbps link is active
Blinking
Data is being transmitted at 10
Mbps
10M GREEN
Off TP Port’s 10 Mbps link is inactive
On TP port’s 100 Mbps link is active
Blinking
Data is being transmitted at 100
Mbps
100M
(TP)
GREEN
Off 100BaseTX Port’s link is inactive
- 11 -