Weidmuller PT 100/4 signal conditioners for voltage output - Manual (Page 3)

17
3.1 Mounting onto TS 35 DIN rails
(s. Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(s. Fig. 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
Warning!! The circuit board can only be inserted in one position.
The connectors have been coded by the manufactur-
er, ensuring that they cannot be reversed.
3.3 Setting the potentiometer (depending on model)
(s. Fig. 3)
The module has been exactly calibrated by the manufacturer.
Should nevertheless a follow-up adjustment be necessary, open
the hinged cover upwards.
The potentiometers are on the front panel.