Weidmuller PT 100/3 sig conditioners for current output - Manual (Page 3)

17
3.1 Mounting onto TS 35 DIN rails
(s. Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(s. Fig. 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
Warning!! The circuit board can only be inserted in one position.
The connectors have been coded by the manu-
facturer, ensuring that they cannot be reversed.