Weidmuller WAVE Analog PRO Thermo - Manual (Page 4)

17
3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top part of
the housing by carefully pressing the latches on
both sides (1). Pull out the top part of the hou-
sing and the electronics section until they lock
(2).
3.3 Settings
Set input and output ranges, minimum input values
and measuring span via the DIP switches SW1 and
SW2 according to the following tables.
When activating variable setting SW 1/8 of the span
or offset, it is possible to make additional adjust-
ments via front potentiometers span and offset, accessible below cover (3).
Caution! Only use a screwdriver which is properly
insulated against the voltage applied to
the input when fine adjusting the poten-
tiometers on the front.
1
1
2
Zero
Span
SW2 SW1
3