Weidmuller WAVE Analog OLP - Manual (Page 3)

8
1. General instructions
Warning! The analogue signal isolators of the WAVE ANALOG may only be in-
stalled by qualified personnel. Be sure not to connect the unit to
power supply before appropriate installation. Do not
select ranges during operation, because live parts are exposed
during this process.
Be sure to observe the national regulations for installation and
selection of cables.
Appropriate safety measures against electrostatic discharge
(ESD) should be taken during assembly and adjustment work on
the WAVE
ANALOG OLP.
2. Application
The analog signal isolator WAVE
ANALOG
OLP is used for the
galvanic isolation and conditioning of current signals and voltage
signals. The input signal can be calibrated via the DIP switch.
It is not necessary to adjust the pre-settable measurement
ranges. The output signal is linear to the input signal.