Weidmuller G118 Ultra SlimPak - Manual (Page 4)

Rated data
Input
Range
Maximum ratings
Field device excitation
Other input specification
Other input specification
Output
Range
Load
Burnout level
Zero / Span adjustment
Protection
Other output specification
Other output specification
Supply
Range
Consumption
Other supply specification
General
Accuracy
Linearity
Temperature coefficient (drift)
Transmission frequency
Response time. 90% span
Other general specification
Status LED
Isolation (# of ports)
Operating / Storage temperature
Housing (mounting)
Dimensions (Lx W x H)
Wire range (conductor size)
Insulation stripping length
Tightening torque
Approvals
Ordering data
Ultra SlimPak
Heat sink (width)
Shunt resistor
RTD temperature sensor, 3 wire
-200 to 850°C for Pt100/Pt500/Pt1000, -200 to 260°C for Cu10/Cu100
-80 to 320°C for Ni120, -200 to 240°C for NiFe604, DIP switch selectable
±5Vdc
<2mA for Pt100, Pt500, Pt1000, Ni120, Cu100 or NiFe604; <10mA for Cu10
leadwire resistance: 40% of base sensor resistance or 100 M (whichever is less), maximum per lead.
leadwire effect: less than 1% of selected span over entire leadwire resistance range.
2 form C relays (2 SPDT), one set point per relay, gold flash/silver alloy
2 set points independently adjustable over 100% of the selected input span, HI or LO, failsafe or non-failsafe
maximum 5A at 120Vac, 2A at 240Vac, 5A at 28Vdc (resistive load), minimum 10 HA at 10mV
deadband adjustable from 1% to 5% of span
external relay contact protection required for inductive load switching
Electrical life: 10 5 operations at rated load
Mechanical life: 10 7 operations no load
DC voltage
9 to 30Vdc, inverter isolated
1.5W typ., 2.5W max. (300mA inrush at 9Vdc).
0.2% of full scale
±0.05% of full scale/°C, max.
<250mS in normal mode, dynamic deadband: relay status will change when proper setpoint/process
condition exists for 100mS
input green (>110% of input: 8Hz, <-10% of input: 4Hz), 2 setpoint red (ON: tripped, OFF: safe)
1800V (3 port) between contacts, input and power
-15°C to 55°C / -25°C to 75°C
EG12 (TS32 and TS35)
90mm x 17.7mm x 112.7mm max.
22-12AWG (0.5-4.0mm 2 )
7mm
0.4-0.8Nm
CSA (file LR-42272), UL (file E99775), CE marked (EMC dir. 89/336/EEC, LV dir. 73/23/EEC)
Cat. No.
G118 (factory calibration: 0-250ºC (Pt 100), A-HI/B-LO, non-failsafe)
HS01-A (1.6mm) (conditionally required depending on installation, see heat sink data)
Note: G118-000X where X is the revision level. For 2 wire sensors: connect RTN and - externally
Specifications subject to change without notice. 99990014 - 8/98 Printed in Canada
RTD
RTD Return
RTD Input (+)
RTD Input (+)
RTD Return
TS32 RAIL
TS35 RAIL