Stand mode operation – Wasp Barcode WDI4600 2D Quick Reference Guide User Manual
Page 27

Operating Modes
Quick Reference Guide
23
Stand Mode Operation
Stand Mode:
In Stand Mode, the illumination remains on for a
configurable amount of time after a good read occurs. The
scanner exits stand mode when movement is detected. If the
trigger is activated from stand mode, the scanner transitions
into one of the triggered modes.
This feature is available starting with firmware
release 610001013.
ENTER/EXIT PROGRAMMING MODE
♦
Stand Mode = Disabled
Stand Mode = Generic Stand
Stand Mode = for All-in-one and Base
Stand Mode = Precise Stand