WarmlyYours TempZone Twin Important - Manual (Page 2)

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
TempZone™ Twin
Important Installation Information
10060-C 2/2012
IMPORTANT: BEFORE STARTING YOUR FLOOR WARMING PROJECT, PLEASE REVIEW
THESE IMPORTANT INSTALLATION INSTRUCTIONS.
NEVER cut the blue warming cable*
NEVER shorten the warming roll*
NEVER connect TWO (2) warming rolls together in series, always wire in parallel
NEVER fold or position the warming system so that the mesh overlaps itself or other warming
cables (this could lead to dangerous overheating)
NEVER run a power lead or sensor wire across the blue warming cable
NEVER place built-in cabinets or furniture with solid, or enclosed bases on top of the heated
area of the floor
(this could lead to dangerous overheating)
NEVER when laying the system on top of a concrete subfloor, lay the warming cable over
an expansion joint
NEVER run a warming cable in or through a wall
NEVER lay the warming system closer than 2” from a wall or heat source
NEVER connect the warming roll to the power supply before it is installed beneath the floor
covering (this could lead to dangerous overheating)
NEVER operate the system until the mortar has had time to cure
*Cutting the warming cable or shortening the roll will:
1. Cause the installed warming system to overheat,
2. Take your installation out of compliance with the NEC (National Electrical Code) and UL
(Underwriters Laboratories), and
3. Require a correction effort that will cost you time and money. CAREFULLY CHECK YOUR
FLOOR PLAN NOW; CALL WARMLYYOURS at (800) 875-5285 if you need a different
length roll shipped overnight.
Note: You can cut and shorten the 15’ cold lead wire coming out of the warming roll.