Vigo VG06031 User Manual

Page 7

MODEL VG06031

TOP VIEW

INSIDE OF THE SHOWER

OUTSIDE OF THE SHOWER

FIG. 6

C. INSTALLING THE DOOR

1. Remove the rollers (#3) from the box, note that these are fully installed. Carefully unthread

the cap with a small head allen key. You will see a big hex screw, this is referred to as the

roller height adjustment screw.

2. Use the provided allen key to unscrew the adjustment screw and dismantle the roller. Place

the screw through door panel top holes and attach the two top rollers onto the door panel

(#5). [SEE FIG.6]

3. Place the two top rollers and the door panel (#5) assembly onto the structural rail (#11).

[SEE FIG.7] Note that the rollers have a built-in mechanism that will provide adjustment for
walls that are not 100% perpendicular to the floor. If necessary, unscrew the adjustment
screw and rotate the individual roller. This will raise or lower the height that the roller sits on
the structural rail. Please refer to pages 13-16 for "Roller Adjustments to Accommodate Out
of Square Openings." Once the rollers are properly adjusted and the door sits straight in the
closed position, the adjustment will be complete. Fully tighten the adjustment screws and
re-install the roller caps. [SEE FIG.6A]
4. Verify that the bottom of the door aligns with the notch in the bottom door guide (#8).
[SEE FIG. 7A]

5. Screw the two bottom rollers (#3) to the door panel. [SEE FIG.7] Rotate the bottom rollers

until they are in the tightest position against the structural rail (#11).

6. Adjust the stoppers' position on the structural rail and tighten the hex screws.

ROLLER HEIGHT

ADJUSTMENT SCREW

OUTSIDE OF

THE SHOWER

FIG. 6A